MIL-HDBK-1331
Handbook for Parameters to be Controlled for the Specification of Microcircuits
FSC: 5962
This handbook describes the parameters required as a minimum for the specification of microcircuits. Parameters, rather than circuits, are considered because circuits vary with the manufacturers involved. Further, circuit designs should be subject to change if improvement results as long as the affected designs are compatible and fully interchangeable. The specific objectives of this document are as follows:
- To provide the minimum parameters that should be specified to ensure adequate evaluation of circuit design and performance.
- To provide maximum commonality of parameters for purpose of test and measurement, within and between major classes of microcircuit types and to allow the recognition of interface problems between types of microcircuits.
- To provide standard abbreviations, definitions and symbols pertinent to the specification of microcircuits.
- To promote maximum interchangeability and compatibility between microcircuits types.
Points of Contact:
MIL-STD-1835 Group
Phone: 614-692-9467, 0591
Email: STD1835@dla.mil
|  |
Document Downloads
Handbook for Parameters to be Controlled for the Specification of Microcircuits
Revision: A, Dated: 22 October 2003
File Name: hdbk1331.pdf, File Size: 128 kb
Parameters to Be Controlled for the Specification of Microcircuits, Handbook for (Validation Notice)
Dated: 20 July 2011
File name: hdbk1331not1.pdf, File Size: 2 kb
Parameters to Be Controlled for the Specification of Microcircuits, Handbook for (Validation Notice)
Dated: 10 May 2016
File name: hdbk1331not2.pdf, File Size: 34 kb
Related Items
An on-line reference for standard microcircuits covered by SMDs and MIL-M-38510 specifications.
Downloads for cross-referencing standard microcircuits
Search for Other documents with FSC 5962
Comments or questions: VaWebTeam@dla.mil